Necessary Tools for Using the Infrared Port

Edit Package irda

This package contains all necessary scripts and programs for setting up
and using the infrared port for printing or communicating. The start
and stop scripts are prepared to access the UART emulation ('SIR' mode)
with 115 kbit/s data transfer rate. This is supported by most laptops
with an infrared interface.

After starting the infrared protocol manager 'irmanger' with the
command 'rcirda start', you can send data to your printer using the
device file /dev/irlpt0. If you like to talk to other computers with
infrared interface or to a mobile phone, you can use the serial
emulation provided by the device file /dev/ircomm0.

Take a look at the README file located in
/usr/share/doc/packages/irda/README and the IRDA HOWTO in
/usr/share/doc/howto/en/IR-HOWTO.gz. If the infrared port on your
laptop is located on an IO or IRQ address other than IO address 0x2f8
(/dev/ttyS1) or interrupt 3, you should use YaST to change the
variables IRDA_PORT and IRDA_IRQ in the configuration file
/etc/rc.config.

Refresh
Refresh
Source Files
Filename Size Changed
52-irda.rules 0000000267 267 Bytes
irda-0.9.18-buildroot.diff 0000000675 675 Bytes
irda-0.9.18-findchip-ppc.diff 0000002385 2.33 KB
irda-0.9.18-irdadump-flush-stdout.diff 0000000428 428 Bytes
irda-0.9.18-irnetd-install.diff 0000000287 287 Bytes
irda-0.9.18-no-findchip-smc.diff 0000000236 236 Bytes
irda-0.9.18-psion-no-strict-aliasing.diff 0000000413 413 Bytes
irda-0.9.18.init 0000002555 2.5 KB
irda-0.9.18.sysconfig 0000001390 1.36 KB
irda-exit_on_error.diff 0000000668 668 Bytes
irda-irdaping_no_strict_aliasing.diff 0000000507 507 Bytes
irda-libpci_with_libz.diff 0000000506 506 Bytes
irda-no_std_paths.diff 0000003050 2.98 KB
irda-optflags.diff 0000000993 993 Bytes
irda-rpmlintrc 0000000125 125 Bytes
irda-utils-0.9.16-fix-off-by-one.diff 0000000446 446 Bytes
irda-utils-0.9.18-fix-irkbd-makefile.diff 0000000403 403 Bytes
irda-utils-0.9.18.tar.bz2 0000138039 135 KB
irda.changes 0000008190 8 KB
irda.spec 0000005354 5.23 KB
Latest Revision
Adrian Schröter's avatar Adrian Schröter (adrianSuSE) committed (revision 1)
Split 12.3 from Factory
Comments 0
openSUSE Build Service is sponsored by