File radvd.changes of Package radvd

-------------------------------------------------------------------
Thu Mar 13 11:29:05 CET 2014 - jbohac@suse.cz

- fix the radvd.service file to use /etc/sysconfig/radvd 
  (bnc#854316)

-------------------------------------------------------------------
Fri Jan 10 14:19:44 CET 2014 - jbohac@suse.cz

- Update to version 1.9.7
  * ioctl bug fix for getting the hardware address and mtu of an interface
- Update to version 1.9.6
  * Check AdvSendAdvert before sending an advertisement
- Update to version 1.9.5
  * IPv6 forwarding setting should be 1 or 2
  * Performance fix in netlink message processing
  * fix for kernels with no NETLINK_NO_ENOBUFS defined
  * distributing gz, bz2 and xz tarballs
  * also distributing md5, sha1, sha256 and gpg signatures
- Update to version 1.9.4
  * IPv6 forwarding setting should be 1 or 2
  * Performance fix in netlink message processing
  * fix for kernels with no NETLINK_NO_ENOBUFS defined
  * distributing gz, bz2 and xz tarballs
  * also distributing md5, sha1, sha256 and gpg signatures
- Update to version 1.9.3
  * check for sys/sysctl.h availability
  * radvdump fix to interpret MTU and Route
- Update to version 1.9.2
  * A few minor Makefile.am fixes
- Update to version 1.9.1
  * Replacing a '==' in configure with '=' for better shell portability
- added .asc (gpg key not yet found)

-------------------------------------------------------------------
Tue Nov  5 12:44:38 UTC 2013 - speilicke@suse.com

- Don't start daemon after package installation, the default config is almost
  useless and previous package versions installed even bad ones into
  /etc/radvd.conf (it would never be fixed since the file is 
  %ghost %config(noreplace)
- Fix try-restart to only restart the daemon if it's actually running. Allow
  condrestart, which is LSB

-------------------------------------------------------------------
Wed Dec  5 19:24:34 UTC 2012 - dimstar@opensuse.org

- Add radvd-tmpfile-grpname.patch: On openSUSE, the radvd user is
  added to the 'daemon' group (not a specific 'radvd' group). Thus
  adjusting the groupname in for the file to be installed in
  tmpfiles.d. Otherwise, the systemd-tmpfiles service fails to
  start (and radvd can't find the /var/run folder).

-------------------------------------------------------------------
Thu Jun 14 16:14:42 UTC 2012 - crrodriguez@opensuse.org

- Remove URL from source as this is a git snapshot 

-------------------------------------------------------------------
Thu Jun 14 01:00:56 UTC 2012 - crrodriguez@opensuse.org

- Update to version 1.9rc1.xxx
 * Support systemd tmpfiles.d 
 * add Native systemd units for this service
 * Uses libdaemon to deamonize and store PID file.
 * Use setsockopt NETLINK_NO_ENOBUFS
 * fixes debian bug 634485

-------------------------------------------------------------------
Fri Dec  2 16:43:39 UTC 2011 - coolo@suse.com

- add automake as buildrequire to avoid implicit dependency

-------------------------------------------------------------------
Wed Nov 16 14:23:54 UTC 2011 - dimstar@opensuse.org

- Update to version 1.8.3:
  + proper tracking of buffer usage in send_ra
- Drop diff_release_1_8_2..44ee01c7.patch: fixed upstream.

-------------------------------------------------------------------
Wed Oct 19 11:53:20 CEST 2011 - jbohac@suse.cz

- Update to version 1.8.3-rc1
- additional patches up to commit 44ee01c7 to fully fix the
  path traversal CVE-2011-3602 (bnc#721968)

-------------------------------------------------------------------
Thu Sep 29 02:15:09 UTC 2011 - crrodriguez@opensuse.org

- Update to version 1.8.1 for details see NEWS
- Fix package building in factory, creating /var/run/radvd before
  being marked as %ghost
- Run spec cleaner

-------------------------------------------------------------------
Tue May  3 14:36:57 UTC 2011 - lnussel@suse.de

- new version 1.7:
  - Fix an unintentional change in 1.3: RAs were accidentally often unicast to
    solicitors instead of being multicast. This is still compliant with the
    specification but is not optimal.
  - Allow radvd.conf prefix, clients, route, and RDNSS options to be in any order.
  - exit if the number of prefixes/routes/etc. would grow too much.
  - Fix radvd skipping multiple interfaces when UnicastOnly is on or
    AdvSendAdvert is off. This got broken in radvd 1.3.
  - Fix a segmentation fault on reload_config() timer list corruption that only
    occurs with multiple interfaces.
  - Add '-c' flag to test configuration.
  - Deprecate old, pre-RFC5006 parameters. Support RFC6106 by adding DNS Search List support.
- run as user radvd by default (bnc#691456)
- clean up init script
- install a small default config that advertises ULAs. Default prefix is
  autogenerated to get a different for on each installation.
- start even if forwarding is not on to be able to work with ULAs only

-------------------------------------------------------------------
Wed Jul 29 11:29:23 CEST 2009 - jbohac@suse.cz

- Update to version 1.3:
    - mainly compilation fixes
    - decreased the default valid and preferred lifetimes
    - support for arbitrary interface names

-------------------------------------------------------------------
Wed Aug 20 15:21:26 CEST 2008 - jbohac@suse.cz

- Update to version 1.1:
    - Implement privilege separation on Linux: a master root 
      process (which is able to reconfigure interfaces) and the 
      main process. There is '-s' toggle to keep old behaviour.
    - Fix Linux retrans_timer on old kernels 
      (newer ones have retrans_timer_ms)
    - Fix stderr+syslog (default) logging on non-i386 platforms.
    - Require that interface must be RUNNING instead of just UP. 
      Note: this could break deployments with very old kernels.
    - Implement automatic interface address advertising with 
      special prefix ::/64.
    - Relax interface naming (e.g. with VLANs) requirements.
    - Fix ordering of route, prefix and RDNSS options (only 
      matters with RDNSS) 

-------------------------------------------------------------------
Tue Nov 27 16:45:46 CET 2007 - jbohac@suse.cz

- Update to version 1.0:
    - Fix AdvDefaultLifetime initalization, broken in 0.9.1.
    - Fix STDERR+syslog logging, don't try STDERR after forking.
    - Implement RDNSS draft with (non-allocated) ND type code 25.
    - Redefined IgnoreIfMissing: failed interfaces are now 
      reinitialized by default. IgnoreIfMissing only omits warnings 
      about these.
    - Unblock SIGALRM at startup.
    - Implement MAX_INITIAL_RTR_ADVERT_INTERVAL handling (upstream 
      fix for #149014)
    - Perform some dynamic/static code audit, fix some minor bugs 
      and do cleanup as a result. 

-------------------------------------------------------------------
Thu Mar 29 16:56:53 CEST 2007 - rguenther@suse.de

- Add bison and flex BuildRequires. 

-------------------------------------------------------------------
Thu Jul 20 16:27:50 CEST 2006 - schwab@suse.de

- Call autoreconf to work around broken time stamps.

-------------------------------------------------------------------
Wed Feb  8 11:58:41 CET 2006 - okir@suse.de

- Make radvd limit the initial RA intervals according to RFC 2461.
  Needed for IPv6 Ready Logo (#149014)

-------------------------------------------------------------------
Wed Jan 25 21:41:04 CET 2006 - mls@suse.de

- converted neededforbuild to BuildRequires

-------------------------------------------------------------------
Mon Dec 12 12:29:36 CET 2005 - okir@suse.de

- Update to latest upstream version 0.9

-------------------------------------------------------------------
Tue Feb 22 14:29:22 CET 2005 - kukuk@suse.de

- Update to 0.7.3 (merge of all fixes)

-------------------------------------------------------------------
Wed Feb  4 11:47:54 CET 2004 - kukuk@suse.de

- Add some patches from RedHat package

-------------------------------------------------------------------
Sun Jan 11 12:47:31 CET 2004 - adrian@suse.de

- add %defattr

-------------------------------------------------------------------
Fri Aug 15 13:11:30 CEST 2003 - kukuk@suse.de

- Add ServiceRestart tag to sysconfig file [Bug #28927]

-------------------------------------------------------------------
Fri Jan 17 13:43:46 CET 2003 - kukuk@suse.de

- Update to version 0.7.2 (VLAN support)

-------------------------------------------------------------------
Thu Jan 16 16:36:02 CET 2003 - kukuk@suse.de

- Add metadata to sysconfig template [Bug #22678]

-------------------------------------------------------------------
Thu Aug  1 15:37:02 CEST 2002 - kukuk@suse.de

- Add PreRequires for insserv and fillup

-------------------------------------------------------------------
Mon Mar  4 17:23:11 CET 2002 - kukuk@suse.de

- Rename OPTIONS variable to RADVD_OPTIONS

-------------------------------------------------------------------
Thu Jan 24 10:42:48 CET 2002 - kukuk@suse.de

- Update to version 0.7.1 (minor fixes)

-------------------------------------------------------------------
Sat Jan 12 22:13:17 CET 2002 - kukuk@suse.de

- Add options to radvd

-------------------------------------------------------------------
Sat Jan 12 20:06:04 CET 2002 - kukuk@suse.de

- Add radvd sysconfig option file
- Don't source rc.config in init script

-------------------------------------------------------------------
Fri Nov 23 16:04:44 CET 2001 - kukuk@suse.de

- update to 0.7.0
- Remove START variable
- Cleanup init script

-------------------------------------------------------------------
Wed Jun  6 18:55:26 CEST 2001 - bjacke@suse.de

- update to 0.6.2pl3

-------------------------------------------------------------------
Mon Apr 23 10:35:11 CEST 2001 - kukuk@suse.de

- Fix type in START variable

-------------------------------------------------------------------
Mon Apr  9 14:13:12 CEST 2001 - bjacke@suse.de

- init script rework

-------------------------------------------------------------------
Mon Feb  5 14:04:08 CET 2001 - bjacke@suse.de

- updated to 0.6.2

-------------------------------------------------------------------
Wed Jan 10 19:20:44 CET 2001 - bjacke@suse.de

- removed service from runlevel 2

-------------------------------------------------------------------
Mon Nov 27 22:24:00 CET 2000 - bjacke@suse.de

- moved init script to /etc/init.d

-------------------------------------------------------------------
Thu Nov 23 14:02:00 CET 2000 - bjacke@suse.de

- use insserv for init.d script

-------------------------------------------------------------------
Mon Nov 13 17:34:13 CET 2000 - bjacke@suse.de

- some specfile fixes

-------------------------------------------------------------------
Mon Oct 28 08:40:42 CEST 2000 - bjacke@suse.de

- initial build
openSUSE Build Service is sponsored by