Recommended update for dracut

This update for dracut provides the following fixes:

- Fix the task limit when running the emergency shell. This fixes a problem that was causing
xfs_repair to crash when trying to repair a damaged XFS filesystem. (bsc#1019938)
- Scan for files in /etc/multipath/conf.d when setting up a multipath configuration.
(bsc#1048551)
- Support AMD CPU families 0x16 and 0x17 (bsc#1072424)
- Make ip=dhcp work. Previously, a network interface specifier was required.
The new behaviour matches documented behaviour.
- Remove 00systemd-bootchart, which is gone from systemd for some time (bsc#1067279)
- support predictable interface names (boo#960669)
- Include crc32c Intel module when using btrfs (bsc#1011554)
- Switch back to fipvlan for bnx2fc (bsc#1052840)
- 95fcoe: Allow bnc2x driver more time to complete DCB negotiation (bsc#1052840)
- 95fcoe: add timeout initqueue entries (bsc#1052840)

This update was imported from the SUSE:SLE-12-SP3:Update update project.

Fixed bugs
bnc#1019938
root filesystem (under LVM) recovery using xfs_repair in dracut segfaults
bnc#1048551
dracut does not include multipath config
bnc#1072424
dracut AMD firmware loading enablement
bnc#1067279
dracut error message: systemd-bootchart could not be found
bnc#960669
udev 228: after update from 13.2/leap 42.1, the network is not enabled
bnc#1011554
btrfs uses slow crc32c implementation
bnc#1052840
fcoemon: error 98 address in use during boot leads to BFS failure
Selected Binaries
openSUSE Build Service is sponsored by