3D printer control software
Cura is a project which aims to be an single software solution for 3D printing.
While it is developed to be used with the Ultimaker 3D printer, it can be used
with other RepRap based designs.
Cura helps you to setup an Ultimaker, shows your 3D model, allows for scaling /
positioning, can slice the model to G-Code, with sane editable configuration
settings and send this G-Code to the 3D printer for printing.
||0000000929 929 Bytes||3 months|
|Cura-4.6.1.obscpio||0102427662 97.7 MB||3 months|
|Cura.obsinfo||0000000094 94 Bytes||3 months|
|_service||0000000537 537 Bytes||3 months|
|cura.changes||0000008445 8.25 KB||3 months|
|cura.spec||0000004885 4.77 KB||3 months|
|disable-code-style-check.patch||0000000493 493 Bytes||over 1 year|