3D printer control software

Edit Package cura

Cura is a project which aims to be an single software solution for 3D printing.
While it is developed to be used with the Ultimaker 3D printer, it can be used
with other RepRap based designs.

Cura helps you to setup an Ultimaker, shows your 3D model, allows for scaling /
positioning, can slice the model to G-Code, with sane editable configuration
settings and send this G-Code to the 3D printer for printing.

Refresh
Refresh
Source Files
Filename Size Changed
Cura-3.6.0.obscpio 0071904271 68.6 MB
Cura.obsinfo 0000000094 94 Bytes
_service 0000000537 537 Bytes
cura.changes 0000005719 5.58 KB
cura.spec 0000003500 3.42 KB
Comments 0
No comments available
openSUSE Build Service is sponsored by