A new user interface for you! Read more...

Cura - 3D Printing software

No description set
Name Changed
Comments for home:Heinervdm:cura 5

John Andrew McInnes

JAMcInnes wrote over 2 years ago

could you add fdm_materials (https://github.com/Ultimaker/fdm_materials) ? I spent a good hour trying to figure out why no materials would show up in cura.. :) Thanks for packaging cura


Thomas Zimmermann

Heinervdm wrote over 2 years ago

I've added the package for you. cura recommends it, so zypper inr should install it.


John Andrew McInnes

JAMcInnes wrote about 2 years ago

I just installed cura from your repo on a fresh Tumbleweed. I found that I had to manually install python3-sip and python3-scipy to get it to run.


Thomas Zimmermann

Heinervdm wrote about 2 years ago

I've added them as dependencies to the cura package, they are not listed as dependencies in the Readmes so i'm not sure if cura or uranium depends on them, this i will check later.

Thanks for reporting.


Thomas Zimmermann

Heinervdm wrote almost 2 years ago

Cura is now available in the science project therefore I will delete this project soon.