PrusaSlicer

PrusaSlicer takes 3D models (STL, OBJ, AMF) and converts them into G-code instructions for FFF printers or PNG layers for mSLA 3D printers. It's compatible with any modern printer based on the RepRap toolchain, including all those based on the Marlin, Prusa, Sprinter and Repetier firmware. It also works with Mach3, LinuxCNC and Machinekit controllers.

Refresh
Refresh
Source Files
Filename Size Changed
PrusaSlicer-2.3.0.tar.gz 0034785471 33.2 MB 13 days
PrusaSlicer.changes 0000005698 5.56 KB 13 days
PrusaSlicer.spec 0000006092 5.95 KB 13 days
_constraints 0000000224 224 Bytes 5 months
Comments for PrusaSlicer 0
openSUSE Build Service is sponsored by