Flash Program for the STM32 Bootloader

Edit Package stm32flash
https://code.google.com/p/stm32flash/

Open source flash program for the STM32 ARM processors using the ST serial bootloader over UART or I2C.

Features:
- UART and I2C transports supported
- device identification
- write to flash/ram
- read from flash/ram
- auto-detect Intel HEX or raw binary input format with option to force
binary
- flash from binary file
- save flash to binary file
- verify & retry up to N times on failed writes
- start execution at specified address
- software reset the device when finished if -R is specified
- resume already initialized connection (for when reset fails, UART only)
- GPIO signalling to enter bootloader mode (hardware dependent)

Refresh
Refresh
Source Files
Filename Size Changed
0001-Fix-for-device-0x442-System-memory-start-address.patch 0000001843 1.8 KB
0003-dev_table-Mark-0x417-0x429-0x427-for-no-mass-erase.patch 0000002730 2.67 KB
stm32flash-0.5.tar.gz 0000041087 40.1 KB
stm32flash-i2c-tools-headers-clash.patch 0000000344 344 Bytes
stm32flash.changes 0000001288 1.26 KB
stm32flash.spec 0000002567 2.51 KB
Latest Revision
Ludwig Nussel's avatar Ludwig Nussel (lnussel_factory) committed (revision 10)
branch from 15.1
Comments 0
openSUSE Build Service is sponsored by