- Update to version 2020-09-R3
* Properly show messages from datasources
* Properly show error and status messages from opening
datasources, which previously were ignored. This should make
seeing errors opening datasources much easier.
* Fix bluetooth capture on some platforms
* Some platforms / kernels / setups appear to not enable rfkill.
The bluetooth hci capture source erroneously failed when no
rfkill information was available.
* Remove 221 IE tag subtype match requirement
* Remove requiring a subtype of 0 on an IE221 tag for matching
the manufacturer of otherwise unknown devices.
* Fix potential crash in datasource panel
* Fix a long-standing potential crash when the datasource panel
is open in the UI caused by a race condition with the
constructor and callbacks.
* Fix race condition in launching datasources
* Fix a long-standing race condition which could lead to some
datasources not being opened properly or their types
autodetected properly due to a race condition with the type
probe code.
* Increase precision of some doubles in JSON for GPS
* Found some legacy serialization code which reduced the
precision of some doubles (double-vector) which would cause
GPS to display with less precision.
* Don’t shut down messagebus processing thread until Kismet is
fully exiting
* The messagebus service thread could shut down before Kismet
had finished spinning down, causing it to not show some of
the errors causing the shutdown. (forwarded request 835703 from mnhauke)