- version 0.80.6
- Merged changes from $OBS/Base:System/sysconfig and SLE-11-SP3.
- Fixed to set link settings on bonding slaves while enslave.
  Before enslaving a new slave, apply link settings like the MAC
  address or MTU to the slave as required e.g. for fail_over_mac
  active, where the bonding interface is using the MAC of the
  currently active slave (bnc#815025).
  [0002-Set-link-settings-on-bonding-slaves-while-enslave.patch]
- Fixed to stop dhcp clients and remove IP addresses on not yet
  enslaved bridge ports and bonding slaves. The bridge or bond
  interface has the IP addresses assigned itself instead.
  The port/slave may still have IP addresses, when the IP config
  of an active (ethernet) interface has been moved into a bridge
  or bond config, e.g. while "virsh iface-bridge eth0 br0". There
  is no full ifdown for the port interface to not break the vlans
  (and their bridges) which may refer to the port too (bnc#813148).
  [0001-Flush-IPs-on-bridge-bond-children-ifup-bnc-813148.patch]
- Add forgotten patch sysconfig-0.80.5.patch
- Accommodate poll.tcpip to systemd
- Fixed to wait for dhcp/ipv6 under systemd again.
  Fixed regression caused by bnc#785240, bnc#780644 fixes to not
  discard the dhcp/ipv6 dupplicate address detection in progress
  error codes under systemd completely, but wait until dhcp/ipv6
  dad finished or the WAIT_FOR_INTERFACES timeout is reached and
  then discard in the status returned to systemd (bnc#808718).
  It caused failures of other services trying to bind tentative
  IPv6 addresses, e.g. in mixed dhcp4 / static IPv6 setups.
  Thanks to Rolf Eike Beer for the report/tests/debug outputs.
  [0001-Fixed-to-wait-for-dhcp-ipv6-under-systemd-again.patch]

• Files Changed
• Browse Source